User's Manual
Table Of Contents
- EX-i Series (TDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the i-Series Radios
- Initial Configuration and Back-to-Back Bench Test
- RF Output Power Setting
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Link Symmetry
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- Access Security Page
- System Configuration Page
- MHS Configuration Page
- Ethernet Interface Configuration Page
- VLAN Configuration Page
- T1/E1 Configuration Pages
- DS3 Configuration Page
- GPS Information Page
- Alarms Page
- MHS Status Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- DIP Switch Settings (-16 Models Only)
- Antennas
- DC Coupler for Antenna Alignment
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Dynamic Frequency Selection
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Regulatory Domain Keys
- EIRP Limits for the United States and Canada
- EIRP Limits for the European Union and ITU Countries
- EIRP Limits for Australia
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- END USER AGREEMENT
- Copyright Notices
- Index
Exalt Installation and Management Guide
EX-i Series (TDD) Digital Microwave Radios
22 206501-019
2016-05-24
The EX-2.4i-16 front panel is shown in Figure 14. The EX-5i-16 front panel is identical, except for the
model number shown in the upper-right corner.
Figure 14 Front panel (EX-2.4i-16 or EX-5i-16)
The EX-5i-DS3 model front panel is shown in Figure 15.
Figure 15 Front panel (EX-5i-DS3)
Connector Overview
The primary user interfaces are shown in Figure 16 provides details of the front panel connectors of the
EX-2.4i EX-4.9i, or EX-5i. Detailed pin structures for each connector are in Interface Connections
.
Figure 16 Primary front panel connectors (standard models)
Table 2 Connectors
Label Type Gender Function
Antenna N F Transmission line connection to antenna.
T1/E1 (1–4 or 1–16) RJ-48C F Primary ports for User T1 or E1 circuits to
traverse link.
DS3 (IN/OUT) BNC F Primary ports for User DS3 circuit to traverse
link.
ETHERNET (MAIN/
AUX)
RJ-45 F Primary ports for user Ethernet and/or
management data (10BaseT or 100BaseT) to
traverse link.
SYNC (IN/OUT) RJ-45 F Internal or external radio synchronizing source
(for example, GPS) input and output.
CONSOLE 9-pin sub-D F Management port (serial) for PC/PDA for
Command Line Interface (CLI)
communications.
ALARMS 9-pin sub-D F External alarm inputs and outputs.