User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
16 202675-008
2016-06-01
• Rear flush mount (rear panel even with the rack mounting surface)
• Rear projection mount (rear panel extended forward from the rack mounting surface)
Figure 7 Rear flush mount configuration
Figure 8 Rear projection mount configuration
Table or Rack Shelf Mounting the System
Affix rubber feet or adhesive-backed non-slip pads (not included) near the corners of the unit along the
bottom panel when mounting on a table or a rack shelf. These pads help keep the radio stable on a
wooden or metal surface.
Radio Ports and Indicators
This section provides a brief overview of the connectors, controls, and indicators on the device. Details
about each item are in other sections of this document.
The EX-6i-DS3-GigE front panel is shown in Figure 7.
Connector Overview
The primary user interfaces are shown in Figure 9. Table 2 provides details of the front panel
connectors. Detailed pin structures for each connector are in
Interface Connections.
Note: Screws for attaching the radio to the telecom rack are not provided; use the appropriate
screw type that matches the equipment rack.
In many areas, it is necessary to strap the equipment to a table or rack shelf if mounting in
this manner. In case of earthquake or other shock or vibration, or an accidental pull of a
cable, the unit should be secured from falling. It may also be necessary to secure the AC
adapter, if it is used.