User's Manual
Table Of Contents
- EX-i Series GigE (FDD)
- Digital Microwave Radios
- Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- List of Figures
- List of Tables
- About this Document
- Introduction
- Pre-installation Tasks
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Command Line Interface (CLI)
- Telnet into the Command Line Interface (CLI)
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- NTP and Time Zone Configurations
- Simple Network Management Protocol (SNMP) Configuration
- File Transfer Page
- File Activation Page
- System Configuration Page
- Allocation Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- MHS Configuration Page
- VLAN Configuration Page
- Ethernet Rate Limiting Page
- Ethernet Learning Page
- Syslog Configuration Page
- Ethernet Aggregation
- Cross Connect (X Connect) Page
- Alarms Page
- MHS Status Page
- Performance Page
- ATPC Statistics Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Ethernet Utilization Page
- PA Control Page
- Spectrum Analyzer
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- EIRP Limits for the United States and Canada
- Licensing 6 and 11GHz Models
- Antennas 5GHz Models
- Copyright Notices
- END USER AGREEMENT
- Index
Exalt Installation and Management Guide
EX-i Series GigE (FDD) Digital Microwave Radios
90 202675-008
2016-06-01
6GHz System Specifications
Frequency Bands Lower 6: 5925–6425MHz
Upper 6: 6525–6875MHz
Output Power Options +27dBm
+30dBm
+33dBm (software-keyed option on +30dBm model)
Selectable Channel Bandwidths Lower 6: 5MHz, 10MHz, 20MHz, 30MHz
Upper 6: 5MHz, 10MHz, 20MHz, 30MHz
Power Control Range 20dB, 0.5dB steps
Receiver Threshold dBm (BER=10
-6
)
a
a. Threshold figures are for 1+0 configurations. If linear combining is used, the threshold improves by 3dB.
Maximum RSL
–30dBm error-free (64QAM); –32dBm error-free
(128QAM and 256QAM)
Regulatory Compliance RF FCC Part 101. EMI FCC Part 15, RSS-210, EN
60 950-1, IEC 950-1, UL 60950-1, SRSP-305.9
Emission Designator(s)
64QAM 128QAM 256QAM
5MHz –79 –76 –73
10MHz –76 –73 –70
20MHz –73 –70 –67
30MHz –71 –68 –65
5MHz 5M0W7D
10MHz 10M0W7D
20MHz 20M0W7D
30MHz 30M0W7D