Installation Manual
Table Of Contents
- ExtendAir eMIMO Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir eMIMO Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization (future feature)
- Radio Synchronization (future feature)
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP) (future feature)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI) (future feature)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- File Management Page
- System Configuration Page
- VLAN Settings Page
- Antenna Alignment Page
- Performance Page
- Metrics – Link Statistics and Radio Interface Statistics Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance–TBD
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir eMIMO Series Digital Microwave Radios
49 208363-001
2013-05-01
System Specifications, 4.9GHz Band
Frequency Band 4940–4990MHz
Output Power (at full power)
+20dBm STBC
a
a. Space-Time-Block Coding allows transmission out of both antennas simultaneously, even for single
stream. Allows double the power for single-stream rates.
Output Power (at minimum power) 0dBm
Selectable Channel Bandwidths 5MHz, 10MHz, 20MHz, and 40MHz
Receiver Threshold (BER=10
-6
)
Non-overlapping Channels
b
b. Not all frequencies/channels are available in all regions.
dBm BPSK QPSK 16QAM 64QAM
5MHz –99 –94 –89 –83
10MHz –96 –91 –86 –80
20MHz –93 –88 –83 –77
40MHz –90 –85 –80 –74
5MHz 10MHz 20MHz 40MHz
10 5 2 N/A