Installation Manual
Table Of Contents
- ExtendAir eMIMO Series Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir eMIMO Series Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization (future feature)
- Radio Synchronization (future feature)
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP) (future feature)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI) (future feature)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- File Management Page
- System Configuration Page
- VLAN Settings Page
- Antenna Alignment Page
- Performance Page
- Metrics – Link Statistics and Radio Interface Statistics Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance–TBD
- EIRP Limits for the United States and Canada
- EIRP Limits for Australia
- EIRP Limits for the European Union and ITU Countries
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty Software License and RMA Procedures Agreement
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir eMIMO Series Digital Microwave Radios
57 208363-001
2013-05-01
Antennas
The ExtendAir eMIMO Series digital microwave radios are intended for use in the USA. In some
countries, antennas exceeding a certain level of gain may be unlawful. Refer to RF Output Power
Setting for details on regulatory limits.
ExtendAir eMIMO Series radios with integrated antennas have software selectable midband gain of 9,
17, or 23 dBi with a beamwidth of 3dB at 60, 20, and 10 degrees, respectively.
Table 6 lists dual-polarity antennas for the ExtendAir eMIMO Series radios.
Table 6 eMIMO Dual-polarity Antennas
Manufacturer Model Number Type Diameter
Gain
(dBi)
Band Support, GHz
4.9 5.3 5.5 5.8
MTI MA-WC56-DP9 Panel 0.5 ft 9 XXXX
Mars MA-WE56-DP12 Panel 0.5 ft 12 X X X
Mars MA-WD56-DP13 Panel 0.5 ft 13 X X X
MTI MT-463012/NVH Panel 1.5 ft 14 XXXX
Mars MA-WE56-DP15 Panel 1 ft 14.5 X X X
KBT KBT65VH15-5158RT0 Panel 1 ft 15 X X X
MTI MT-463013/NVH Panel 1.5 ft 15.5 XXXX
Mars MA-WD55-DS16 Panel 1 ft 16 XXXX
Mars MA-WD56-DP16 Panel 1 ft 16 XXXX
Mars MA-WD56-DSV16 Panel 1 ft 16 XXXX
Mars MA-WD62-DS16 Panel 1 ft 16 X
Mars MA-WD62-DP16 Panel 1 ft 16 X
MTI MT-484052/NVH Panel 0.5 ft 16 XXXX
KBT KBT65DP17-5158RT0 Panel 1 ft 17 X X X
Mars MA-WC55-DS17 Panel 1 ft 17 XXXX
Mars MA-WC62-DP17 Panel 1 ft 17 X
KBT TDJ-5158BKR×2 Panel 1 ft 18 X X X
Mars MA-WC56-DP17 Panel 1 ft 18 XXXX
MTI MT-485005/VHN Panel 0.5 ft 18 X X X
Mars MA-WA56-DP19 Panel 0.5 ft 19 XXXX
MTI MA-WA56-DP19 Panel 0.5 ft 19 XXXX