User's Manual
Table Of Contents
- ExtendAir® (TDD) Series Direct Mount Digital Microwave Radios Installation and Management Guide
- Legal Notice
- Open-Source License Information
- Table of Contents
- About this Document
- Introduction
- Pre-installation Tasks
- Link Engineering and Site Planning
- Familiarization with the ExtendAir® (TDD) Series Direct Mount Radios
- Initial Configuration and Back-to-Back Bench Test
- Time Division Duplex (TDD) Factors
- Link Orientation and Synchronization
- Radio Synchronization
- Offset Timing
- Virtual Local Area Network (VLAN)
- Simple Network Management Protocol (SNMP)
- System Installation and Initiation Process
- Installation
- Configuration and Management
- Telnet into the Command Line Interface (CLI)
- Telnet
- Exalt Graphical User Interface (GUI)
- Quick Start
- Navigating the GUI
- Radio Information Page
- Administration Settings Page
- Simple Network Management Protocol (SNMP) Configuration
- File Management Pages
- File Transfer Page
- File Activation Page
- System Configuration Page
- Ethernet Interface Configuration Page
- T1/E1 Configuration Pages
- VLAN Configuration Page
- Ethernet Rate Limiting
- GPS Information Page
- Alarms Page
- Performance Page
- Event Log Page
- User Throughput Page
- Diagnostic Charts Page
- Spectrum Analyzer Page
- Ethernet Utilization Page
- Reboot Page
- Manual Page
- Specifications
- Interface Connections
- Antennas
- Troubleshooting
- Back-to-back Bench Testing
- General Compliance and Safety
- Safety Notices
- Regulatory Notices
- Regulatory Compliance
- Conducted Power Limits for the United States and Canada
- Declaration of Conformity to the R&TTE Directive 1999/5/EC
- Exalt Limited Hardware Warranty
- Copyright Notices
- Index
Exalt Installation and Management Guide
ExtendAir
®
(TDD) Series Direct Mount
000000-001 105
2011-08-26
Index
A
AC adapter 25
Administration Settings page 38
administrator privileges 32
Advance Encryption Standard 39
AES 39
AIS enabling//disabling 53
alarm conditions 35
alarms 52, 60
clearing 64
Alarms page 60
AMI 53
antennas
alignment 28, 84
Canada 91
mounting height 5
site preparation considerations 5
troubleshooting 84
B
B8ZS 53
back-to-back bench test 7, 86
back-to-back bench test configuration 86
Bandwidth parameter 48
battery source 25
BER 67
browsers 31
buzzer timeout selection parameter 51
C
cables
Ethernet (CAT5) 7
RF 5
T1/E1 7
troubleshooting
improper RF cable termination 83
CLI 30
main menu 30
configuration file 43
connections
RSL Sync 77
sync distribution accessory 78
TDM 77
Two-radio pin Internal Sync Out/In 78
connectors 22
GPS/RSL 23
Power/Ethernet 23, 78
T1/E1 1&3 23
T1/E1 2&4 23
TDM 77
Current BER field 62
Current RSL field 62
D
date and time 38
DC power source 25
Diagnostic Charts page 67
dimensions-ExtendAir models 74
duplex settings 52
Dynamic Frequency Selection (DFS) 49
E
E1 channels 54
E1 Interface Configuration page 54
effective isotropic radiated power (EIRP) 8
Endpoint Identifier 33, 47
Errored Seconds (ES) field 63
Ethernet configuration parameters 54
Ethernet connectors 78
Ethernet interface 76
throughput settings 53
Ethernet Interface Configuration page 52
Event Log page 64
ExaltCalc tool 82
external loopback modes 55
F
factory default settings 27, 44
fade margin 5, 85
File Activation page 44, 46
File Transfer page 43
file transfers 43
files
activating stored 46
default configuration file 44
flywheeling 14
frame length See TDD frame
frequency
center 5
G
gateway (default) 45
GPS Information page 59
GPS synchronization 50, 59
GPS/RSL connector 23
GPS/RSL LED 24
grounding 84
GUI