Owner`s manual

Page | 13
Remote Control Setup
The e20 DAC is pre-programmed to work with the supplied remote control. If you like, you can
reprogram the e20 DAC to work with a different IR remote control. The exaSound e20 DAC can be
trained to recognise commands from most infrared remote controls using Sony and NEC IR protocols.
Use the following procedure to change remote control button assignments or to pair the e20 DAC with a
different remote control:
1.
Power on the
e20
DAC. Mak
e sure that the unit is not in
playback mode.
2. Press the Setup button.
3.
Press the
Volume Up
button to
conf
i
rm the
remote control
programming mode, or press the Volume Down button to
cancel the operation.
4.
Point the remote control to the
e20
DAC disp
lay.
P
ress and hold
down the remote control buttons for about one second during
each step below to assign functions to them.
5. Press the remote control button for increasing the volume.
6.
Press the remote control button
for
decreasing
the volume
.
7.
Press the remote control button
for
selecting the next input
.
8.
Press the remote control button
for
previous input
.
9.
Press the remote control button
for turning the unit on and off
.
10.
Press the remote control button
for
mute
.
11.
Wait until the re
mote control configuration is saved. Your
e20
DAC is now paired for use with the new IR remote control.