User’s Guide for Beverage Buggy Ages 7+ Model No.
C ongratulations on your purchase of Excalibur Electronics’ Beverage Buggy. You and your friends will enjoy hours of fun driving your Beverage Buggy. Your Beverage Buggy is easy to use but be sure to use it safely. Before starting, please read this manual thoroughly, especially noting safety, care and battery information. Keep this manual for reference. This package contains 1 Beverage Buggy, 1 transmitter, 1 antenna, 1 tube for antenna, 1 battery cartridge and 1 manual.
Your Beverage Buggy Includes... Functions of Buttons LEFT JOYSTICK TRANSMITTER: right, as shown in Figures 1 and 2. TRIM SWITCH CONTROL: The trim switch is located on the underside of your Beverage Buggy. This is used to align the wheels for consistent straight-line driving. Switch left or right to align the wheels. ON Push up to drive the vehicle forward. Push down to drive the vehicle in reverse, as shown in Figures 1 and 2. RIGHT JOYSTICK TRANSMITTER: ON Push left to steer the vehicle left.
How to Play To begin, insert the antenna wire through the hollow tube. Avoid pulling the wire too tight. The wire is on the top of your Beverage Buggy. Tie a knot on top to secure, as shown in Figure 3. allow you to drive it forward, reverse, left and right. Use both joysticks to turn. If you want to turn right while driving forward, push the right joystick right and push the left joystick up. If you want to turn left while driving in reverse, push the right joystick left and push the left joystick back.
INSTALLING BATTERIES To install batteries in the transmitter, please follow these steps: 1. Remove the battery cover located on the back. 2. Install one 9-volt battery making sure to match the polarity (+ and -) with the diagram inside the battery compartment. 3. Replace the battery cover. To install batteries in your Beverage Buggy, please follow these steps: 1. Remove the battery cartridge located on the underside of the vehicle by turning the lock and lifting the cartridge off. 2.
• • • To protect your Beverage Buggy’s wheel mechanism from lint, thread, hair and dust particles, you can use a small brush, tweezers or tie a small bit of cloth to the tip of a toothpick, etc., and wipe it off. Always keep your Beverage Buggy clean. Use a dampened cloth to wipe off, and then wipe all the water off with a dry cloth. Never use chemicals to clean the product. Avoid holding the wheels when they are rotating.
EXCALIBUR ELECTRONICS, INC. 13755 SW 119TH AVENUE MIAMI, FLORIDA 33186 U.S.A. PHONE: 305.477.8080 FAX: 305.477.9516 Play games live at: www.ExcaliburElectronics.