Excalibur Electronics Porsche 1:12 Operating Manual Model No. www.ExcaliburElectronics.com 907R 907T 921BK 921S (Red, 49 Mhz.) (White, 27 Mhz.) (Black, 49 Mhz.) (Silver, 27 Mhz.
C ongratulations on your purchase of Excalibur Electronics’ radio-controlled Porsche 1:12 Scale car. This full-function model has turbo power to give you the fastest possible speed when you want it. Other features include super suspensions, a recharging jack (optional), air-filled rubber tires, telescopic antenna, front-wheel steering trimmer and a fully detailed interior.
REMOTE CONTROL TRANSMITTER BATTERY INSTALLATION: Find the battery compartment on the back of the unit. Use a small Phillips screwdriver to remove the screw. (See diagram below, left.) Remove the battery cover by sliding the latch in the direction of the arrow. (See diagram at left, below.) Install one 9V battery (not included) in the compartment, making sure to match polarity (+ and -) with the diagram inside the battery compartment. Replace the battery cover. Then replace the screw and tighten gently.
CHARGING THE NICKEL-METAL HYDRIDE BATTERIES WITH OPTIONAL CHARGER: To order the optional charger, see page 9. When the car starts moving slowly or quits moving, it’s time to recharge the nickelmetal hydride batteries. To recharge the batteries, you will need a battery charger (not included). CHARGING PROCEDURE: Insert the charger’s barrel plug into the battery box charging jack, and then plug the charger’s other end into a standard AC outlet. Push all the way forward to obtain TURBO speed.
CAUTION: • Charge only nickel-metal hydride batteries. Recharging any other batteries could cause serious damage and possibly an explosion. • Do not use the battery charger in wet or hot areas. • Use the charger in areas where there is a free flow of air. • Do not charge the battery pack immediately after use. Allow it to cool first. • Never mix alkaline and nickel-metal hydride batteries. • Make sure to match polarity (+ and -) with the diagram inside the battery compartment.
Special Care & Handling • Avoid rough handling such as bumping or dropping. • Avoid moisture and extreme temperatures. For best results, use between the temperatures of 39ºF and 100ºF (4º C and 38º C.) • Clean using only a slightly damp cloth. Do not use cleaners with chemical agents. • • • Battery Information Batteries should be installed or replaced only by an adult. Your Porsche 1:12 uses 8 AA batteries for the car and one 9V battery for the transmitter, not included.
Excalibur Electronics, Inc. 13755 SW 119th Ave Miami, Florida 33186 U.S.A. Phone: 305.477.8080 Fax: 305.477.9516 Play games live at: www.ExcaliburElectronics.
