User’s Guide for Forever FlashlightTM** Rip Cord www.ExcaliburElectronics.com Model No.
C ongratulations on your purchase of the Forever Flashlight Rip Cord from Excalibur Electronics, Inc. Your Forever Flashlight Rip Cord is the perfect accessory for your next outdoor adventure and it will never let you down. At home, in the car, in your camper or boat or storm emergency kit, the Forever Flashlight Rip Cord is always ready, even if you have not used or checked it for years! Your Forever Flashlight Rip Cord is easy to use, but be sure to use it safely.
Features Layout of Forever Flashlight Rip Cord CHARGING LED ON/OFF/SIREN/ INDICATOR BLINKING LIGHT • • WRIST BAND SUPER BRIGHT LED FLASHLIGHT RUBBER BACK COVER DC 6V INPUT RIP CORD 4 CELL PHONE CHARGING OUTPUT • • • • • • • • Our Forever Flashlight Rip Cord combines an LED flashlight, emergency siren and charging capability into one handy unit. Includes the new technology of a Rip Cord 3-Phase Motor.
How to Use Charging the Forever Flashlight Rip Cord Charging your unit using your built-in rechargeable batteries. Your Forever Flashlight Rip Cord includes two great options to charge your unit. For directions on each option see right: It is charged by pulling the RIP CORD on the unit. Your RIP CORD is located in the rear of the flashlight under the RUBBER BACK COVER. For best results, follow these steps in charging: 1. Turn the unit off. Diagram 1 6.6 LBS Important.
properly. The recommended pull speed would be 80 pulls per minute. • If your unit is completely drained of energy, you should pull the RIP CORD again three to five minutes. Keep in mind, that if the Forever Flashlight Rip Cord has not been utilized for a long length of time, it will cause the battery life to be shorter than normal even after recharging. Charging your unit using an AC/DC adaptor.
This can provide up to two minutes of talking time with this process. The phone’s cell life can also be extended by continuing the pulling the RIP CORD during the phone’s use. 3. Plug the other end of your phone charge cord into your personal cell phone. 4. Once phone is plugged into its charge cord continue to pull the RIP CORD for one minute (approximately 80 pulls per minute). Caution • • Specifications • • • • • • • Outer dimension: 5'' x 1.75'' x 1.75'' Weight: 0.40 lbs 5mm LED: 5x @ 9200mcd, 0.
• • • • • • • • • Special Care & Handling Always turn off the flashlight when charging. Do not charge for more than 24 hours straight. This could damage the unit’s recharging system. Avoid rough handling such as bumping or dropping. Avoid extreme temperatures. For best results, use between the temperatures of 39º F and 100º F (4º C and 38º C). Clean only using a slightly damp cloth. Do not use cleaners with chemical agents.
LIMITED 90-DAY wear and tear, inadequate maintenance, commercial use, or unreasonable use of the unit. Removal of the top panel voids all warranties. This warranty does not cover cost of repairs made or attempted outside of the factory. EXCALIBUR ELECTRONICS, INC., warrants to the original consumer that its products are free from any electrical or mechanical defects for a period of 90 DAYS from the date of purchase. If any such defect is discovered within the warranty period, EXCALIBUR ELECTRONICS, INC.
EXCALIBUR ELECTRONICS, INC. 13755 SW 119TH AVENUE, MIAMI, FLORIDA 33186 U.S.A. Phone: 305.477.8080 Fax: 305.477.9516 Play games live at: www.ExcaliburElectronics.