Use and Care Manual

4. Insert an orange plastic spacer A with the short end

down on one short T- bolt B, then insert the head of

the bolt in the front upper slot in the fence body as

shown in C.

3. Attach the second mounting bracket to the oppo-

site side of the table, A.

Note: Adjust the height of the 3 bolts in the slotted holes in

the rail bracket so that the rail is leveled with the table, B.

5. Slide the 2 bolts and spacers to the middle of the

fence body (approx.)

6. Install the orange dust shield A on the two bolts and

secure in place using two flat washers B and 2 lock

knobs C as shown in D.

7. Secure the dust shield in place by tightening the two

lock knobs.

Note: The dust shield can be adjusted in height along the

T-slots.

8. Insert a long T-bolt A through all 6 holes in the fence

body B and, from the other side of the fence, loosely

attach a flat washer C and lockknob D.

Note: Do not tighten down the lock knobs; leave the T-

head of the bolts protruding from the fence.