Use and Care Manual

4. Remove the lift and lock the adjuster screw in place

by turning the lock nut A clockwise (tighten).

3. From the underside of the table, adjust the 4 phillips

head screws in the corners A - up or down until the

plate is flat and level with the table surface.

2. Use a straightedge to test the plate for level with the

table top.

1. Place the router lift into the opening in the table.

Note: Model #40-070 for 40-100C Cast-iron table shown. The following steps apply to all 3 table options.

5. After the four corners are set, proceed to set the

remaining 6 leveler screws and lock them in place.

Note: While tightening the lock nut, make sure that the

adjuster screw does not turn. Confirm by re-checking the

leveling of the lift and table surface.

PREPARE THE TABLE FOR THE ROUTER LIFT