Use and Care Manual

BASIC ADJUSTMENTS & CONTROLS

ADJUSTING THE FENCE ALONG THE RAILS

The fence can be slid along the rails A. Loosen locking

handles B, slide fence then lock in position by re-tight-

ening the locking handle. Repeat on the other extrem-

ity of the fence.

ADJUSTING THE FENCE FACES

Depending on the size of the workpiece and the bit being used, the white fence faces can be adjusted along the

fence body A. Loosen the 3 lock knobs, B on one side of the fence and then slide the fence face up to where you

need it to be. Then lock in position by re-tightening the lock knobs. Repeat with the second fence face on the other

side of the fence body.

Note: Do not slide the fence faces too far and off the first T-bolt head, as shown in C.

The scale on the rails can be adjusted along the rails

C. Loosen lock knob D, slide the fence up to where you

need it to be, then lock in position by re-tightening the

lock knob. Repeat for the sliding scale on the other rail.

ADJUSTING THE SLIDING SCALE ON THE RAILS

CONNECTING THE ROUTER TO THE SAFETY SWITCH

1. Remove the top half of the power cord flange plate

from the side panel on the dust containment box A.

2. Pass the router’s power cord through the opening as

shown in B, taking just enough cord to reach the

inlet on the back of the safety switch box.

BEFORE TURNING ON THE SWITCH ON YOUR ROUTER,

MAKE SURE THE SWITCH ON THE SWITCH BOX IS IN

THE OFF POSITION AND THAT THE SWITCH BOX IS NOT

YET CONNECTED TO A POWER SOURCE.

3. Re-install the power cord flange plate and plug the

router into the inlet on the back of the safety switch.

Note: Make sure to leave enough of the router’s power cord

inside the dust containment box to allow you to remove the

lift and the router from the table opening from above.