Use and Care Manual

INSTALLATION
6
T
HE MACHINE IS HEAVY (119 LBS - 54 KG). DO NOT OVEREXERT. ARRANGE TO HAVE HELP NEARBY AND READY FOR UNPACK-
ING AND SET UP.
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE COM-
P
LETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL INSTRUCTED
T
O DO SO.
SAFETY
ROUTING MAY PRESENT SERIOUS INJURY HAZARDS TO UNTRAINED USERS. BE SURE TO READ, UNDERSTAND, AND FOL-
LOW ALL INSTRUCTIONS AND SAFETY GUIDELINES SUPPLIED WITH THE ROUTER YOU WILL INSTALL ON THIS TABLE.
MAKE SURE THAT ADEQUATE HEARING PROTECTION IS USED AND THAT THE OVERALL SOUND LEVEL WITHIN THE WORK-
ING ENVIRONMENT IS TAKEN INTO CONSIDERATION.
INSTALL THE ROUTER TABLE ON A STABLE SURFACE
MOUNTING TO A WORK SURFACE
If a permanent shop placement is practical, consider
removing the rubber feet on the base and drilling
matching through holes in the mounting surface of your
workbench or stand to bolt the table in place (hard-
ware not included) on your workbench.
If a permanent installation is not practical, clamps can
also be used to secure the table to a bench or work
table.
The unit should be installed on a flat, sturdy and stable
surface or workbench able to support the weight of
the machine and the workpiece with ease.
ORDER OF ASSEMBLY
D
A
C
E F
G
B
A- Stand legs
B- Hex head bolt
C- Flat washer
D- Workbench or stand
E- Flat washer
F- Lock washer
G- Hex nut
Never install the machine over the edge of a table
or workbench.