Installation guide
Step 1 T
urn the ignition key “ON”, then “OFF”
Step 2 Within 5 seconds of step 1, press the valet switch 5 times to access user features (Press
10 times to access installer features)
�
~ The siren/horn will sound and the status light will turn on�
Step 3 Within 10 seconds of step 2, press the valet switch the number of times corresponding
with the desired feature’s number�
~ The siren/horn will chirp equal to the selected feature�
Step 4 Change the feature by pressing the transmitter button that corresponds with the desired
setting�
~ The siren/horn will chirp equal to the selected setting�
Step 5 If you wish to change more features, repeat steps 3 & 4 at this time�
Step 6 T
o exit programming, turn the ignition key “ON” then “OFF”
� Or, you can wait 10 seconds
for programming mode to expire�
This device complies with FCC Rules part 15� Operation is subject to the fol-
lowing two conditions, (1) This device may not cause harmful interference and,
(2)
This device must accept any interference that may be received, including
interference that may cause undesired operation
�
The manufacturer is not responsible for any radio or TV interference caused by
unauthorizedmodicationstothisequipment.Suchmodicationscouldvoidthe
user’
s authority to operate the equipment
�
A matrix of all programmable features and their options are on the next page� For detailed infor-
mation on each feature, please refer to the operation manual� Use the procedure below to make
any necessary changes�
PROGRAMMING FEATURES
Programmable Features