Technical data

NEW EXCALIBUR

English

• Remove the suction pipe and take away the solvent tank.

• Point the gun into the solvent tank and press the trigger so

as to recover the residual solvent.

• As the pump idles, press the “OFF” (0) switch to stop the

tooling.

• Now the machine is ready. Should you use water paints,

besides the solvent wash, a wash with soapy and then clean

water is suggested.

• Insert the gun trigger lock and assemble the nozzle.

PREPARATION OF THE PAINT

• Make sure the product is suitable to be used with a spray gun.

• Mix and ﬁlter the product before using it. For ﬁltration, use

CLOSE-MESH (ref. 214) and LARGE-MESH (ref.215) LA-

RIUS METEX braids.

Absolutely avoid to spray solvents indoors. In

addition, it is recommended to keep away from

the pump in order to avoid the contact between

the solvent fumes and the electric motor.

Never use products containing halogen hydrocarbons (as methy-

lene chloride). If these products come into contact with aluminium

parts of the equipment, can provoke dangerous chemical reactions

with risk of explosion.

Make sure the product to be used is compatible

with the materials employed for manufacturing the

equipment (stainless steel and aluminium).

Because of that, please contact the supplier of the

product.

• Point the gun (F3) into a container (F8) keeping the trigger

pressed (so as to drain the oil inside) till a clean solvent comes

out. Now, release the trigger.

WORKING

START OF THE PAINTING OPERATIONS

• Use the tooling after performing all the SETTING UP ope-

rations above described.

• Dip the suction pipe (G1) into the product tank.

• Open the recirculating-safety valve (G2) (turn clockwise so

as the pin slides on the cam track).

OPEN

It re-circulates back into

the tank without spraying

CLOSED

It sprays out of the spray

gun

G2G2