Technical data

NEW EXCALIBUR

English

LED

ALARMS

• Flashing lamp (G4) for alarms:

ALARMS

Maximum current exceeded

Overheating Head Control

Overheating motor

(not implemented)

High voltage feeding current

Low voltage feeding current

No earthing

Faulted pressure sensor

CLEANING AT THE END OF THE WORK

• Reduce pressure to the minimum (turn counterclockwise the

pressure control knob (H1) ).

• Press the switch (H2) placed on the box of the electric motor,

to stop the equipment.

• Release the residual pressure by holding down the trigger of

the gun and pointing it into a container.

• Open the recirculating-safety valve (H3) to release the pressure

in the circuit.

• Lift the suction pipe and replace the product tank with that

of the solvent (ensure it is compatible with the product being

used).

• Unscrew the gun nozzle (do not forget to clean it with solvent).

• Press the switch (H2) ON and turn a little the pressure

control knob (H1) clockwise so as the machine works till

the motor starts.

• Make sure the solvent recycles the washing ﬂuid from the

return tube.

• Close the recirculating-safety valve (H3).

• Point the gun (H4) into the product tank (H5) and, keeping

the trigger pressed, release the remaining product till a clean

solvent comes out. Now, release the trigger.

Recycling stop (after 15 min.)