Use and Care Manual

ATTACHING THE LEVELING FEET

If you prefer, an optional stand (item EX-21BS for EX-16

& EX-21 or item EX-30BS for EX-30) is available from your

local General International dealer. The stand is equip-

ped with mounting holes allowing the saw, after re-

moving the leveling feet, to be bolted directly to the

stand.

INSTALLING THE OPTIONAL STAND

Install the leveling feet as shown. Loosen the upper A

and lower B nuts as needed to adjust the height of the

foot.

FOR YOUR SAFETY IT IS ESSENTIAL THAT THE MACHINE DOES NOT ROCK OR TIP DURING OPERATION. UPON START-

UP OR DURING OPERATION, IF YOU NOTICE ANY ROCKING, TIPPING OR CHATTERING OF THE BASE TURN THE

MACHINE OFF IMMEDIATELY AND READJUST THE LEVELING FEET AS NEEDED TO STABILIZE THE SCROLL SAW ON THE

BENCH OR WORK SURFACE

MOUNTING TO A WORK SURFACE

If a permanent shop placement is practical, consider

removing the leveling feet on the base and drilling

matching through holes in the mounting surface of your

workbench or stand to bolt the saw in place (hardware

not included) on your workbench.

If a permanent installation is not practical, clamps can

also be used to secure the saw to a bench or work

table.

The unit should be installed on a flat, sturdy and stable

surface able to support the weight of the machine and

the workpiece with ease.

Never install the machine over the edge of a table or

orkbench.

INSTALL THE SAW ON A STABLE SURFACE

ORDER OF ASSEMBLY

E F

A- Saw

B- Hex head bolt

C- Flat washer

D- Workbench or stand

E- Flat washer

F- Lock washer

G- Hex nut