3822 Next Generation 2.4 GHz Monitor Quick Start Instructions You'll find detailed instructions Inside. Please read the safety instructions on page 2. 1. Set up the Parent's Unit a. Install the hatted es supplied. b ong of the two AC adapters provided into the Parent's Unit, re for 10 to 16 hours (18 preferred). Note: You may use the Monitor while it Is being changed. <. Once batteries are , unit can be used in portable mode {without the AC adapter}. 2. Set up the Child's Unit a.
This symbol is intended to alert the user to the presence of Important operating and maintenance (servicing) instructions in the literature accompanying the product. This symbol is intended to alert the user to the presence of insulated “dangerous voltage” within the product's enclosure that may be of sufficient magnitude to constitute a dsk of electric shock. — . RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE. 2. OBSERVE ALL WARNINGS. 3. FOLLOW ALL OPERATING INSTRUCTIONS. 4.
Parent's Unit 1. Install the batteries . a. Press on the indented finger grip to release, then slide and lift the battery compartment cover. b. Insert the two AA rechargeable batteries supplied. Position them so the + and contacts are aligned with the corresponding contacts on the battery clip. ©. Lower the battery compartment cover, and slide It until it clicks into place. When It's time to change these batteries: Use the pull tab to release the old baited es.
2 To Use Monitor Note: Banalities must be Sully charged for portals tse, 1. Slide tha canoeing switch on the Child's Unit to hither sen the unit oa, 2. Side tha channelize switch on the Parent's Uni to the same channel ag the Child's Unit (A or Bl This tums the unit on, (For tha Monitor to work property, both units must be aot to the samey channel} A Tur the volume dial on the Parent's Unit associates to the desired journals level, 4, Keep the Parent's Unit with you.
Parent's Unit Recharging Batteries: . ‘When the power Indicator on the Parent's Unit is red, power is low. It’s best to begin recharging the unit immediately. If the power indicator is not lit, the batteries are dead, To recharge, follow the steps in “To Set Up,” Parent's Unit, #2. For best results: Recharge only after the Monitor bas been in use for 8 to 1%hours or when the power indicator turns red, Recharging too frequent will shorten battery life.