Manual

HOW TO APPLY CHEMICALS
AND CLEANING SOLVENTS
Applying chemicals or cleaning
solvents is a low pressure operation.
NOTE: Use only soaps and chemicals
designed for pressure washer use_ Do
not use bleach.
To Apply chemicals:
1. Press chemical
hose onto
barbed fitting
located near high
pressure hose
connection of
pump as shown
2. Place other end of chemical
hose with filter on it into container
holding chemical/cleaning
solution° NOTE: For every 7
gallons of water pumped 1 gallon
of chemical/cleaning solution will
be used,
3. Install low pressure (black}
nozzle into quick connect fitting
of spray wand, see How To Use
Spray Wand paragraph in this
section.
4. After use of chemicals, place
chemical hose into container
of clean water and draw
clean water through chemical
injection system to rinse
system thoroughly, If chemicals
remain in the pump it could be
damaged. Pumps damaged due
to chemicals will not be covered
under warranty.
NOTE: Chemicals and soaps will not
siphon when spray wand is in the high
pressure setting,,
STARTING
Prior to starting, refer to your engine
manual for proper starting procedure.
1. In a well ventilated outdoor
area add fresh, high quality,
unleaded gasoline with a pump
octane rating of 86 or higher. Do
not overfill. Wipe up spilled fuel
before starting the engine,. Refer
to Engine Owners Manual for
correct procedure.
2. Check engine oil level. See
Engine Owners Manual for correct
procedure.
3. Verify the filter
screen is in
water inlet of
pump_ NOTE:
Cone side
faces out,,
4. Connect water
source to pump inlet. NOTE:
Water source must provide a
minimum of 5 gallons per- minute at
2O PSI.
5. Connect high pressure hose to
pump outleL
Water
Source
6. if applying a chemical or
cleaning solution, see How
To Apply Chemicals/Cleaning
Solvents instructions in this
section°
7. Turn water source on.
NOTE: Failure to do so could
cause damage to the pump.
At2335 10-ENG