Manual

When perlorming
maintenance_ you
may be exposed to hot surfaces,
water pressure, or moving parts that
can cause serious injury or death!
Before performing any maintenance
or repair, disconnect spark plug
wire, let engine cool and release
all water pressure. The engine
contains flammable fuel. DO NOT
smoke or work near open flames
while performing maintenance.
To ensure efficient operation and
longer life of your pressure washer; a
routine maintenance schedule should
be prepared and followed., If the
pressure washer is used in unusual
conditions, such as high-temperatures
or dusty conditions, more frequent
maintenance checks will be required.
ENGINE
Consult the Engine Owners
Manual for the manufacturer's
recommendations for any and all
maintenance. Consult the Engine
Owners Manual for the manufactur _
er's recommendations for any and
all maintenance_ NOTE: The frame is
equipped with an oil drain hole to help
make changing the engine oiI easier.
PUMP
The pump on this unit is maintenance
free and requires no oil, if there is a
problem with the pump contact an
Authorized Service Center.
NOZZLE CLEANING
If the nozzle becomes clogged
with foreign materials, such as dirt,
excessive pressure may develop. If
the nozzle becomes partially clogged
or restricted, the pump pressure will
pulsate. Clean the nozzle immediately
using the nozzle kit supplied and the
following instructions:
1. Shut off the pressure washer and
turn off the water supply.
2= Pull trigger on gun handle to
relieve any water pressure.
1
4.
Disconnect the spray wand from
the gun.
Remove the high-pressure nozzle
from the spray wand. Remove
any obstructions with the nozzle
cleaning toot provided and
backflush with clean water:
5. Direct water supply into spray
wand to backflush loosened
particles for 30 seconds_
6. Reassemble the nozzle to the
wand,
7. Reconnect spray wand to gun
and turn on water supply_
8. Start pressure washer' and place
spray wand into high pressure
setting to test°
HOW TO CLEAN THE WATER
iNLET FALTER
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove filter
by grasping end
and removing
it from water
inlet of pump as
shown,
2. Clean filter by flushing it with
water on both sides.
3. Re-insert filter into water inlet of
pump, NOTE: Cone side faces out_
NOTE: Do not operate pressure
washer without filter properly installed_
At2335 12- ENG