Manual

Compare the illustrations with your unit to familiarize yourself with the location
of various controls and adjustments. Save this manual for future reference.
Quick
Connect
Spray Wand
Spray
Gun
High
Pressure
Engine
High Pressure
Pump (located
inside the
shroud)
BASIC ELEMENTS OF A
PRESSURE WASHER
High Pressure Pump (located inside
the shroud): Increases the pressure
of the water supply.
Engine: Drives the high pressure
pump.
High Pressure Hose: Carries the
pressurized water from the pump to
the gun and spray wand°
Spray Gun: Connects with spray
wand to control water flow rate,
direction, and pressure.
Quick Connect Spray Wand: Allows
the user to quickly change out high-
pressure nozzles. See How To Use
Spray Wand instructions in this section_
Chemical Hose (not shown): Feeds
cleaning agents into the pump to
mix with the water, See How To
Apply Chemicals/Cleaning Solvents
instructions in this section,
BASRC ELEMENTS OF AN
ENGINE
Refer to the engine manual for
location and operation of engine
controls.
Choke Control: Opens and closes
carburetor choke valve_
Starter Grip: Pulling starter grip
operates recoil starter to crank
engine.
Engine Switch: Enables and disables
ignition system,
PRESSURE WASHER
TERMINOLOGY
PSI: Pounds per Square Inch_ The
unit of measure for water pressure,
Also used for air pressure, hydraulic
pressure, etc,
GPM: Gallons Per Minute, The unit of
measure for the flow rate of water,
CU: Cleaning Units, GPM multiplied
by PSI_ GPM x PSI = CU
7_ ENG A12335