Specifications

9-ENG 1000003473
ASSEMBLY

1 - Air Compressor
1 - Parts bag containing:
1 - Owner’s Manual
4 - 5/8" Washers
1 - Conduit Connector

1 - 9/16" socket or open end wrench
1 - Electric drill

1. Remove all packaging.
           


2. Remove and discard the (4) screws and washers holding the compressor to
the pallet.
3. With the help of another person carefully remove air compressor from pallet
and place on a level surface.

     




• Locatetheaircompressorinaclean,dry,andwellventilatedarea.
• Locatedtheaircompressoratleast12"(30.5cm)awayfromthewallor
other obstructions that will interfere with the flow of air.
• Locatetheaircompressorasclosetothemainpowersupplyaspossible
to avoid using long lengths of electrical wiring.  Long lengths of
electrical wiring could cause power loss to the motor.
• Theairfiltermustbekeptclearofobstructionswhichcouldreduceairflow
to the air compressor.

        
        

The air compressor MUST be bolted to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete anchors (not supplied)
4 - 5/8" Washer (supplied) shims (if needed)
1. Place the air compressor on a solid, level surface.
2. Mark the surface using the holes in the air compressor feet as a template.
3. Drill holes in the surface for the concrete anchors. Install concrete anchors.