User guide

Chapter 2 Installation and Setup
2-6
Life|point
®
InTouch Phone User Guide
Connect Handset Battery
You need to connect the battery in the cordless handset in order to register the handset to the Base in
the next section. Use a #6 TORX screwdriver to remove the screw for the battery cover. Do not attempt
to use any other kind of tool to remove this screw. Refer to the diagram below to remove the handset
battery cover and connect the battery:
Connect
Plug
TORX
Screwdriver
TORX
Screw
When you have connected the handset battery, replace the cover. Place the handset in the Base or
a charger and allow it to charge until the battery indicator on the handset’s LCD screen is colored in,
indicating a full charge. Then proceed to the next section, Register Handset(s) To Base.