User guide

Chapter 2 Installation and Setup
2-7
Life|point
®
InTouch Phone User Guide
Register Handset(s) to Base
Once the Base is connected to the network and associated with a room, you need to register the
handset(s) to the Base. The recommended distance from handset to Base during registration is 4 feet.
If you have just entered the room number for this Base on a previous screen on the Base display, the
access code will be displayed and you can go to Step 5. If the Room UI is displayed, begin with Step 1.
Contact hotel technical services and obtain the daily code. 1.
On the 2. Base display, touch Phone. The phone menu displays a number touchpad.
Touch 3. # followed by the daily code from hotel technical services.
Touch4. * (the star key). A screen displays with two options: Association and Cordless Registration.
Touch 5. Cordless Registration. The screen displays a menu with a four-digit access code.
On the 6. handset’s number keypad, press *278*123456#.
Press the green phone button. The handset admin menus display on the handset’s LCD screen.7.
Use the volume control on the left side of the handset to scroll down to 8. System.
Press the green phone button.9.
Using the volume control, scroll to 10. Register Handset.
Press the green phone button.11.
Using the volume control, scroll to 12. Register.
Press the green phone button. The handset LCD displays 13. Enter Password.
Enter the four-digit access code from the Cordless Registration screen on the 14. Base display.
Press the green phone button. The handset displays 15. Searching. Please Wait.
When the handset displays 16. Please press OK to Register, press the green phone button. After a few
moments, the handset displays Registered. A popup will appear on the Base display telling you to
wait 10 seconds for registration to complete. WAIT 10 SECONDS for these three things to occur:
The 10-second popup disappears•
The • Base display updates to include the handset you just registered
The handset displays its main page.•
Note: If the handset does not return to the main page, refer to the Troubleshooting Chart in
chapter 8 and follow the instructions in the entry for handset registration failures.
Repeat Steps 6 through 16 for each additional handset that will be registered to this Base.17. When all
handsets are registered, touch Done on the Base display. Wait until the Base displays the Room UI.
Perform this step on each handset registered to this Base18. . Press the green phone button to place the
handset “off hook”. Listen for a dial tone. If dial tone is not present, refer to the Troubleshooting Chart
in chapter 8 for instructions for dial tone failures. If dial tone is present, press the red phone button to
hang up. When you have performed this step on all handsets, commissioning is complete.