User guide

Chapter 7 Standalone Charger
7-2
Life|point
®
InTouch Phone User Guide
Charger Setup
Note: Before using cordless handset(s) that are included with the standalone charger, refer to Chapter
2, Installation and Setup to connect the handset battery and register the handset to the Base.
To set up the standalone charger and charge a cordless handset, refer to the diagram below and
perform the following steps:
Charging a Cordless Handset
USB
Port
Connect the USB end of the power supply’s cable to the USB jack on the rear of the charger. 1.
Connect the prongs on the power supply end of the cable to a wall outlet.2.
Insert the cordless handset into the charger base as shown.3.
The blue LED on the front of the charger will turn on to indicate charging. When the handset is fully 4.
charged, the battery indicator on the handset’s LCD screen will be fully colored in.
Note: Whenever the handset is in the charger, the blue LED turns on.