Users Manual Part 1

Radio Frequency Interference

· Vehicles Equipped with Airbags — For driver and passenger safety

,avoid mounting the radio s control head (or any other component)

’

above or near airbag deployment areas. In addition to driverside and passenger-side front-impact airbags, some vehicles may also be

equipped with side-impact airbags. For occupant safety, verify the location of all airbags within the vehicle before installing the radio

equipment

FCC Part 15

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference; and,

2. This device must accept any interference received, including interference that may cause undesired operation.

Important Information

NOTE 1: This equipment has been tested and found to comply with the limits for a Class B digital device , pursuant to part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

NOTE 2: Any changes or modifications to this unit not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

- This radio is designed for and classified as “Occupational/Controlled Use Only”, meaning it must be used only during the course of

employment by individuals aware of the hazards, and the ways to minimize such hazards; NOT intended for use in an General

population /uncontrolled environment.

- DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF

exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna specifically authorized by

the manufacturer for use with this radio.

- DO NOT transmit for more than 50% of total radio use time, more than 50% of the time can cause RF exposure compliance

requirements to be exceeded.

This equipment should be installed and operated with a minimum distance of 70cm between the radiator and your body.