Use and Care Manual

50-PIECE COMPOSITE AIR TOOL KIT
3/8" AIR RATCHET WRENCH
C2
B2
D2
C2
B2
D2
28
1. How to install/tighten threaded fasteners.
Turn the F/R knob (C2) counterclockwise to “F”
position (F=Forward or Tighten). Press the
trigger (D2). The tool anvil (B2) runs clockwise.
(See Figure 28)
2. How to remove/loosen threaded fasteners.
Turn the F/R knob (C2) clockwise to “R” position
(R=Reverse or Loosen). Press the trigger (D2).
The tool anvil (B2) runs counterclockwise.
(See Figure 29)
29
30
AIR HAMMER
C3
1. Hold the tool firmly with both hands. Bring the
tool towards the workpiece at an angle of
60-70 degrees approximately.
2. Press the trigger (C3) slowly with the chisel in
light contact with the workpiece. (See Figure 30)
3. Slowly move the chisel across the workpiece
surface.
NOTE: When removing scale, rust or
other contaminants, you only need to
apply a light force on the tool.
NOTE: Keep the chisel contacting the
workpiece while you are releasing the
trigger to stop operation. The tool may
impact briefly after the trigger is
released.
20