Use and Care Manual

50-PIECE COMPOSITE AIR TOOL KIT

13. Always store this product in a dry and safe place out of reach of children or

untrained operators.

Air die grinder safety instructions

1. Always use the die grinder in the manner and for the functions described in this

manual.

2. Always ensure the grinder is not moving and disconnected from the air supply

when changing grinding stones etc.

3. Only use qualified grinding stones. Never use chipped or cracked grinding stones.

4. Always ensure that the grinding stone is correctly installed onto the tool before

starting the tool.

5. Avoid direct contact with the grinding stone during and after use as it can be hot

and sharp. Wear suitable gloves to protect hands.

6. Use respiratory protection when working in certain materials which creates

emission of dust and fumes.

7. If necessary, use clamps or proper devices to securely fix the workpiece.

8. Never carry the grinder by the air supply hose.

9. Always disconnect the tool from the air supply when the grinder is not required for

immediate use in order to avoid accidental start.

10. Always ensure that the grinder has come to a complete stop before putting it down

after use.

11. Do not discard the safety instructions. Give them to the operator.

12. Always store this product in a dry and safe place out of reach of children or

untrained operators.

WARNING! Compressed air can be dangerous. Ensure that you

are familiar with all precautions relating to the use of compres-

sors and compressed air supply.

1. Use only clean, dry, regulated compressed air as the power source.

2. Make sure that the air compressor being used for the tool operation supplies the

correct output (CFM).

3. Have the tool in "off" position when connecting the tool to the air supply.

4. Use normal 90psi working pressure for the tool. High pressure and unclean air will

shorten the tool life due to the faster wear and also may create a safety hazard.

5. Drain water from the air compressor tank daily, as well as any condensation in the

air lines. Water in the air line may enter the tool and cause damage to the tool

mechanisms at operation.

6. Clean the tool air inlet screen filter for blockage weekly. Clean if necessary.

7. Usually a 3/8" (inner diameter) air hose is recommended for air supply and airflow

to get the optimum performance of tool.

8. A long air hose (usually over 25 feet) may cause up to 15psi drop in pressure, so

you need to set the output pressure of the air compressor higher to maintain the

required working pressure at the tool.

AIR SUPPLY

Please refer to the typical air system layout recommended below.