User Manual
XP600/1100/2000INSTALLATION ANDOPERATIONMANUAL
TURN ON INVERTER:
XP-600, XP-1100 and XP-2000:
TURN ON APPLIANCE/LOAD:
1.
2.
Note:
Note:
Turn inverter on using Toggle Switch
on Front Panel, or the "REMOTE" switch if installed. LED next to the
switch will illuminate, indicating the inverter is operational.
(If either switch is "on", the inverter will turn on. Both switches
must be off for the inverter to turn off.)
Check Input Power Requirements of the appliance. Make sure
that it is less than Rated Output Power of the inverter. If more than
one appliance will be run simultaneously, the sum of their Input
Power Requirements must be less than Rated Output Power of the
inverter.
If using "REMOTE" switch, the Front Panel Switch must be
off.
If Appliance/Load has been hard wired to the barrier terminal strip
asillustratedin Appendix"C",thenturnapplianceon.Otherwise,plug
the appliance into the provided receptacle on Front Panel, then turn
appliance on.
It is recommend that the inverter be turned ON before the
appliance/load.
.
.
.
.
.
.
.
Operation
4.0
Page11