Instructions / Assembly

9
ASSEMBLY
Figure A
Step 1
1A. Frame Set Up: Extend the Front Frame (1) and the Rear Frame (2). Rest the Rear Frame
Support Tube (67) into the hooked plate on the Front Frame (1). Align the upper pin holes of both
frames. Then insert the Safety Pin (22) into the Front Frame (1) and the Rear Frame (2) to lock
the frames in place. See Figure A.
1B. Front Stabilizer Installation: Attach the Front Stabilizer (31) onto the front curve of the Rear
Frame (2). Secure with two Hexagon Nut Caps (29) and two Curve Washers (30), and then
tighten using the 13-15mm Wrench provided.
1C. Rear Stabilizer Installation: Attach the Rear Stabilizer (3) onto the rear curve of the Front
Frame (1). Secure with two Hexagon Nut Caps (29) and two Curve Washers (30), and then
tighten using the 13-15mm Wrench provided.
HARDWARE PACK
Front Stabilizer (31)
Transport Wheels
TOOL
13,15mm Wrench
1PC
(22) Safety Pin
1 PC
(29) Hexagon Nut Cap
4PCS
(30) Curve Washer
4 PCS