Instructions / Assembly

21
MAINTENANCE & TROUBLESHOOTING
MAINTENANCE
Cleaning
The bike can be cleaned with a soft, clean damp cloth. Do not use abrasives or solvents on the
plastic parts. Wipe your perspiration off the bike after each use. Be careful not to get excessive
moisture on the computer display panel as this might cause an electrical hazard or the electronics
to fail. Keep the computer console and the bike, out of direct sunlight to prevent screen damage.
Inspect all assembly bolts, nuts, screws, and pedals on the machine for proper tightness every
week.
Storage
Store the bike in a clean and dry environment away from pets and children.
TROUBLE SHOOTING
PROBLEM: The Computer (9) does not turn on.
SOLUTION: Remove the Computer (9) and verify that ALL wires that come from the
Computer (9) are properly connected to the wires coming from the Front Frame (1).
PROBLEM: There is no heart rate reading or the heart rate reading is erratic / inconsistent.
SOLUTION: Make sure that the wire connections for the hand pulse sensors are secure.
SOLUTION: To ensure the pulse readout is accurate, always hold on to the handlebar grip sensors
with two hands instead of just with one hand.
SOLUTION: Avoid gripping the hand pulse sensors too tight. Try to maintain even pressure while
holding onto the hand pulse sensors.
PROBLEM: The bike makes a squeaking noise when in use.
SOLUTION: The bolts may be loose on the equipment. Check all of the nuts, bolts, screws and
tighten any loose Hardware.
PROBLEM: The pedals came unscrewed while in use.
SOLUTION: Reinstall the pedals and if you cannot then contact Customer Service.
PROBLEM: How to reset the data on display.
SOLUTION: Hold the Mode Key down for 3-10 Seconds, this will reset the display (Note: The
Odometer will not be reset. To reset odometer, remove the batteries from the Computer (9).