Instructions / Assembly

TROUBLESHOOTING

PROBLEM: The pedals came unscrewed while in use.

SOLUTION: Reinstall the pedals. If you are unable to do so, contact Customer Service.

PROBLEM: How to reset the data on display.

SOLUTION: To clean the workout data, press the RESET key. The ODOMETER will not be reset.

To reset the ODOMETER, hold the MODE key for 3 seconds. This will change units from MPH to

KMPH, hold the MODE key for 3 seconds again to return to your desired units.

PROBLEM: High Tension on all settings

SOLUTION: Remove the Handle Cover (60) to verify that the Tension Control Knob (23) is

properly connected to the Tension Cable (64). If not, un-hook the cables and reinstall the Tension

Control Knob (23). (See Figure Below)

SOLUTION: Make sure part Clip (64A) is removed. (See Figure Below)

SOLUTION: Turn the tension knob to tension level one, and then pull the Tension Control Knob

(23) cable up as high as you can as this will reset the tension.