Instructions / Assembly

18
ASSEMBLY
Step 9
Installing the Rear Rod & Heel Holders:
9A. Slide the Rear Rod (5) through the Adjustable Boom (3) with the slots facing forward. Secure
the Rear Rod (5) with one Hex Bolt (45), one Metal Bushing (44), one Flat Washer (43), and one
Nylon Nut (42). Tighten the hardware using the Hex Wrench and Multi-Hex tool with Phillips
Screwdriver provided.
9B. Wrap the Rubber Heel Holders (14) with the Steel Heel Holder Bracket (7). Squeeze the
Steel Heel Holder Brackets (7) and Rear Rubber Heel Holders (14) and slide them onto both
ends of the Rear Rod (5). Ensure the lock teeth are wedged into the slots in the Rear Rod (5) as
shown in the Fig. C.
NOTE: Make sure the lock teeth are wedged into the slots in the Rear Rods (5) before
use. See Fig. C.
Tools:
Hex Wrench 1PC
Multi Hex Tool with Phillips
Screwdriver 1PC
(45) Hex Bolt
1PC
(43) Flat Washer
1PC
(42) Nylon Nut
1PC
(44) Metal Bushing
1PC
Hardware:
Fig. C