Owner's manual

Test Setup

EXpert IP 27

Configuration (LAN Discovery)

From the Main Menu, tap LAN Discovery, and the Configuration tab.

Configuration

 Start IP Address: Enter the start range of the IP Address from where

you want to start discovering the LAN in the network: 0.0.0.1 to

223.255.255.255. The default value will be the first 2 bytes of the

network in which the device is connected. For example, if the network

address is 10.192.3.83, then the default value will be 10.192.0.0.

 End IP Address, when selected, allows to enter the end range of the IP

Address up to where you want to discover the LAN in the network:

0.0.0.1 to 223.255.255.255. The default value will be the IP address of

the device. This will be same as the IP address in test interface page.

Note: If you run the LAN Discovery test using the Start IP address and the Subnet

Mask or Bit Mask, then the provided Start IP address parameter is used for

masking the bits, it is not considered as the starting IP address for the LAN

discovery.

 Mask is a logically visible subdivision of an IP network. It allows to

create a range of IP addresses that could be used to scan over the IP

network during the LAN discovery: 255.255.240.0 to 255.255.255.255

(default is 255.255.240.0).

 Bit Mask: Enter the binary network mask: 20 (default) to 32.

Services to Search

Allows the selection of services for which the LAN Discovery test will

interrogate network devices: DHCP, FTP, SNMP, DNS, HTTP, Telnet, HTTPS,

SSH, and SIP.

Select All check box when selected selects all services.