User guide

Remote Control
100 FLS-2600B
Specific Commands
SOURce:SWEep:REPeat
Description This command is used to specify how many times you want the
sweep program to repeat.
Syntax SOUR:SWE:REP<wsp><repeat>
Parameters The <repeat> parameter is a boolean parameter indicating
whether or not the sweep program will be repeated:
 1: the sweep program will be repeated continuously.
 0: the sweep program will be repeated for the number of
times set by the SOUR:SWE:COUN command.
Example SOUR:SWE:REP 1
Note You cannot use this command during a sweep.
See also SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP?,
SOUR:SWE:REV and SOUR:SWE:REV?
SOURce:SWEep:REPeat?
Description This query is used to check how the sweep repeat function is
activated.
Syntax SOUR:SWE:REP?
Response A boolean value indicating the state of the sweep repeat
function:
 1: the sweep repeat function is continuous.
 0: the sweep repeat function is set to the number entered
with the SOUR:SWE:COUN command.
See also SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP,
SOUR:SWE:REV and SOUR:SWE:REV?