User guide

Remote Control
Tunable Laser Source 101
Specific Commands
SOURce:SWEep:REVerse
Description This command is used to enable and disable the sweep reverse
function. When this function is enabled, the sweep program is
performed in both directions: ascending and descending.
Syntax SOUR:SWE:REV<wsp><sweep>
Parameters The <sweep> parameter is a boolean parameter indicating
whether or not the sweep will be performede in both
directions:
 1: enable the sweep reverse function.
 0: disable the sweep reverse function.
Example SOUR:SWE:REV 1
Note This command cannot be performed during a sweep.
See also SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP,
SOUR:SWE:REP? and SOUR:SWE:REV?
SOURce:SWEep:REVerse?
Description This query returns a value indicating whether the sweep
reverse function is enabled.
Syntax SOUR:SWE:REV?
Response A boolean parameter representing the state of the sweep
reverse function:
 1: the sweep reverse function is enabled.
 0 : the sweep reverse function is disabled.
See also SOUR:SWE:MODE, SOUR:SWE:MODE?, SOUR:SWE:CENT,
SOUR:SWE:COUN, SOUR;SWE:COUN?, SOUR:SWE:REP,
SOUR:SWE:REP? and SOUR:SWE:REV