User guide

Remote Control
104 FLS-2600B
Specific Commands
SOURce:SWEep:SPAN?
Description This query returns the wavelength range to be swept below and
above the central wavelength.
Syntax SOUR:SWE:SPAN?
Response A value representing the wavelength range to be swept below
and above the central wavelength in 9999.999 nm or
999.9999 THz format.
Note If you do not specify a unit, the system will return the value in
the current spectral units (nm or THz). To specify the units you
want to use, add NM or THZ after your query
(e.g., SOUR:SWE:SPAN?<wsp>NM).
Example SOUR:SWE:SPAN?
SOURce:SWEep:SPEed
Description This command allows you to select the sweep speed for the
continuous mode.
Syntax SOUR:SWE:SPE<wsp><speed>
Parameters The <speed> parameter is set in the 99.999 nm/s or
9.9999 THz/s format.
Example SOUR:SWE:SPE 35.455
Note You cannot use this comment while the FLS-2600B is
performing a sweep.
If you do not specify a unit, the system will use the current
spectral unit (nm/s or THz/s). To specify the units you want to
use, add NM/S or THZ/S after your query
(e.g., SOUR:SWE:SPE<wsp><speed><wsp>NM/S).
See also SOUR:SWE:SPE?