User guide

Remote Control
Tunable Laser Source 139
FLS-2600B Error and Warning Messages
101 The command request was
not performed in the set time
amount.
Retry command or wait until
there are no commands in the
pipe.
102 The command was not
performed by the Tunable
Laser Source due to a
runtime error.
Contact EXFO.
103 A command has triggered an
invalid response from the
Tunable Laser Source.
Retry the command.
200 The Tunable Laser Source
had difficulties while
downloading or
decomposing information.
Restart the Tunable Laser
Source.
1106 The sweep parameter not in
the range expected by the
SOUR:SWE:STAT SCPI
command.
Modify your sweep parameters
so that they are all within the
acceptable range.
32244 An overflow occurred while
running a command.
Restart the Tunable Laser
Source.
32245 Not enough RAM to run the
command.
Restart the Tunable Laser
Source.
32246 The Tunable Laser Source
used a command not
intended for it.
Restart the Tunable Laser
Source.
32300 Not enough space in the
Heap.
Restart the Tunable Laser
Source.
32301 Not enough RAM to run the
command.
Restart the Tunable Laser
Source.
Error or
warning
Number
Description Recommended Action