User guide

Safety Information
10 FLS-2600B
Electrical Safety Information
WARNING
To avoid electrical shock, do not operate the unit if there are signs
of damage to any part of the outer surface (covers, panels, etc.).
To avoid serious injury, you must observe the following precautions
before turning on the unit.
 If the unit is to be powered via an auto-transformer for voltage
reduction, the common terminal must be connected to the
grounded power-source pole.
 Insert the plug into a power outlet with a protective ground
contact. Do not use an extension cord without a protective
conductor.
 Before turning on the unit, you must connect the protective
ground terminal of the unit to a protective conductor using the
unit power cord.
 Do not tamper with the protective ground terminal.
Equipment Ratings
Relative humidity 0 % to 80 % non-condensing
a
a. Measured in 0 °C to 31 °C (32 °F to 87.8 °F) range decreasing linearly to 50 % at 40 °C
(104 °F).
Maximum operation altitude 2000 m (6150 ft)
Pollution degree 2
Overvoltage category II
Power supply rating
b
b. Not exceeding ± 10 % of the nominal voltage.
100 V to 240 V (50 Hz/60 Hz)
maximum 2 A