User guide

Tunable Laser Source 15
4 Setting Standard Parameters
Setting the Display Intensity
You might want to set the display intensity of your unit, or turn the
display off.
To change the display intensity:
1. Press Setup.
2. Turn the selection dial clockwise until DIMMER is displayed.
The current dimmer status appears.
3. Press ENTER. The Edit marker starts blinking in the lower part of the
display.
4. Turn the selection dial until you see the desired display intensity (LO,
HI, OFF, or Auto. OFF), then press ENTER.
Setting the dimmer to OFF turns off the display. Press any key to turn the
display back on.
Setting the dimmer to Auto. OFF also turns off the display. Press any key to
turn the display back on. However, after five seconds, the display will
automatically turn off again.
5. To exit the Setup menu, press Setup.
Edit