User guide

Setting Standard Parameters

Tunable Laser Source 19

Selecting a Wavelength

There are several ways to select a wavelength for testing.

Entering a Wavelength Directly

To select a wavelength, make sure you are in Wavelength Edition mode.

To select the Wavelength Edition mode, press the



List button on the

front panel, so that



appears on the upper left-hand corner of the display.

To select a specific wavelength, turn the selection dial clockwise or

counterclockwise until you reach the desired wavelength. The module will

then set the wavelength according to your selection.

If the set power cannot be maintained at the selected wavelength

(especially at extreme wavelengths), the displayed power value will flash,

a message appears in the status bar, and the power is no longer in constant

power mode. The output power stability and level will be the natural laser

emission.

To stop the power display from flashing and have the power regulation

work again, set the wavelength at an interval where the displayed power

can be reached, or decrease the power.

Normal



Fine-tune

dBm