User guide

Setting Sweep Parameters

32 FLS-2600B

Setting the Pauses

6. Press ENTER to validate your choice, and Sweep to exit the menu.

Turn the dial clockwise or counterclockwise until EXIT is displayed,

then press ENTER.

Note: If the sweep wavelength range is not a multiple of the step value selected,

the stop wavelength will be truncated to the nearest possible value, thus

reducing the range.

Setting the Pauses

You can set a time interval or pauses between steps. First, make sure you

have selected the Step-by-Step sweep mode. For more information, see

Selecting the Sweep Mode on page 30.

To set the length of the pauses between the steps:

1. Press Sweep.

2. Turn the selection dial clockwise until PAUSE is displayed.

3. Press ENTER. The Edit marker starts blinking in bottom left-hand

corner of the display.