User guide

Remote Control

74 FLS-2600B

Changing the Flow Control for RS-232

Handshake controls are software mechanisms controlling data flow along

a serial line. The most common requirement is for flow control to match

the data transmission rate to a rate the device can process.

The computer and the terminal (in this case, the FLS-2600B) stop each

other transmitting by sending a control character (xoff), and cause

transmission to restart by sending another control character (xon). This is

known as a software handshake.

To change the handshake flow control for RS-232 transfer, you must be in

RS-232 mode. To select the RS-232 mode, see Setting the FLS-2600B for

Remote Control on page 71.

To change the flow control:

1. Press Setup.

2. Turn the selection dial clockwise until FLOW is displayed. The current

setting appears.

3. Press ENTER. The Edit marker starts blinking in the lower part of the

display.

4. Turn the selection dial to choose the desired setting for the flow: Soft.

(xon/xoff) or None.

5. Press ENTER.

6. To exit the Setup menu, press Setup.

Edit