Instruction Manual

Preparing Your MAX-700 for a Test

42 MAX-700

Cleaning and Connecting Optical Fibers

To connect the fiber-optic cable to the port:

1. Inspect the fiber using a fiber inspection microscope. If the fiber is

clean, proceed to connecting it to the port. If the fiber is dirty, clean it as

explained below.

2. Clean the fiber ends as follows:

2a. Gently wipe the fiber end with a lint-free swab dipped in isopropyl

alcohol.

2b. Use compressed air to dry completely.

2c. Visually inspect the fiber end to ensure its cleanliness.

IMPORTANT

To ensure maximum power and to avoid erroneous readings:

 Always inspect fiber ends and make sure that they are clean as

explained below before inserting them into the port. EXFO is

not responsible for damage or errors caused by bad fiber

cleaning or handling.

 Ensure that your patchcord has appropriate connectors. Joining

mismatched connectors will damage the ferrules.