User's Manual

EX7100 Technical Manual - List of Figures
©1999 Exicom Technologies (1996) Limited x Issue 2 - May 2001
Page
7.12 Location of Loop Volts adjustment CV101 7-19
7.13 VHF RF Power Amplifier Module in Place within an EX7100 Terminal 7-23
7.14 VHF PA Module Test set-up 7-25
7.15 Bottom Cover Screws for VHF PA Removal 7-26
7.16 Heat Sink Screws for VHF PA Removal 7-26
7.17 UHF RF Power Amplifier Module in Place within an EX7100 Terminal 7-28
7.18 UHF PA Module Test set-up 7-30
7.19 Bottom Cover Screws for UHF PA Removal 7-31
7.20 Heat Sink Screws for UHF PA Removal 7-31
7.21 VHF Receiver Module in Place within Terminal 7-34
7.22 VHF Receiver Module Fault Diagnostic Tree 7-36
7.23 UHF Receiver Module in Place within Terminal 7-40
7.24 UHF Receiver Module Fault Diagnostic Tree 7-42
7.25 Location of Loop Volts adjustment CV101 7-43
7.26 VHF Duplex Filter Adjustment Locations 7-49
7.27 UHF Duplex Filter Adjustment Locations 7-53
7.28 Modem/Controller Block Diagram 7-57
7.29 Modem/Controller in Place within Terminal 7-57
7.30 Modem/Controller Fault Diagnostic Tree 7-59
7.31 Front Panel Block Diagram 7-61
7.32 Front Panel Fault Diagnostic Tree 7-62
7.33 Six Channel Line Interface Connection Block Diagram 7-64
7.34 Subscriber Line Interface in Place within Terminal 7-65
7.35 Exchange Line Interface in Place within Terminal 7-65
7.36 Six Channel Line Interface Fault Diagnostic Tree 7-67
8.1 EX7100 Repeater 8-1