User's Manual

14
Adding an Alarm to Your multiLINX Network
To add an alarm(s) to an existing multiLINX network, perform the following steps.
Select any alarm on the existing network.
Press
and hold
the button on the front cover of the
alarm. The red WARNING or FIRE light will flash
rapidly and the alarm will sound four tones.
Next, the yellow WARNING light will flash slowly.
Count to
5 flashes of the yellow WARNING light
and release the button.
If done correctly, the blue RADIO light will now
slowly pulse, indicating the network is again ready
to receive additional alarms.
After one minute, the RADIO light will stop
flashing on the original alarm and the network
will again close.
The alarm has been successfully added to
your network!
To add a new alarm, simply slide the switch
located on the back side of the alarm in the
direction indicated by the arrow. It will lock into
place when fully positioned.
The blue RADIO light will flash briefly, then the
alarm will chirp twice and all four of the lighted
icons will strobe on in succession.
Continue holding the button down.
If not, wait about 15 seconds and carefully repeat
these steps.
If the alarm being added was previously used,
follow the steps on Page 13 to erase its multiLINX
data. Then re-open this alarm’s radio networking
using steps 1-2 in this section.
Heat Manual 06_02_13.indd 14Heat Manual 06_02_13.indd 14 8/5/2013 12:49:20 PM8/5/2013 12:49:20 PM