User manual

indicator will be lit green when the TechSetter performs certain functions, such as media

cut and media form feed.

3.2 Keypad

This key allows the operator to cycle through the MENU selections during TechSetter

OFF LINE: SYSTEM menu, JOB menu, IMAGE menu or Print the System Setup.

ITEM

This key allows the operator to cycle through all the ITEMs listed under one of the basic

menus.

ON LINE

This key switches the TechSetter between ON LINE and OFF LINE. The TechSetter will

be ready to receive data only during ON LINE, with the ON LINE indicator on the panel

lit green.

ENTER

This key allows operator to go from MENU to ITEM selection and also to save the

selected parameter into the TechSetter's "permanent" memory. Two asterisks "**" will

appear next to the parameter to indicate that it is now the default. As a "permanent"

default, the selection will remain valid even if the TechSetter is switched OFF, or RESET

is performed.

CUT/PARM+

This key initiates the plotter MEDIA CUT function only when the "Imager OFF LINE"

message is on the display. It is also used as a parameter scroll up key (PARM+) when

the TechSetter is in the ITEM mode.

FEED/PARM-

This key will move the media 4" long only when the OFF LINE message is on the

display. It is also used as a parameter scroll-down key (PARM-) when the TechSetter is

in the ITEM mode.

When parameters are displayed for a selected ITEM, the PARM+ and PARM- keys

allow the operator to cycle up or down through the parameter selections (options) that are

available.