User manual

7
3.3 Menu and Item Modes
Table 1 shows the menus and menu items available with the basic TechSetter
configuration. Detailed description of menu items is given below.
After the TechSetter is powered up, the default state is ON LINE, with the ON LINE
indicator lit green and the message "TechSetter 1400" displayed. Press the ON LINE
key to switch the TechSetter to the OFF LINE state.
After "... OFF LINE" appears on the display, pressing the MENU key causes the first
menu (SYSTEM menu) to appear. Pressing the ITEM or ENTER key enables the ITEM
mode, causing the first item (see Table 1) to appear on the display. Pressing the ITEM
key will cycle through all the items under the current menu. When the TechSetter is in
the ITEM mode, pressing the MENU key will exit the ITEM mode and go back to the
MENU mode.
Table 1 - MENU SELECTION
TechSetter
Off Line →
SYSTEM
menu →
JOB
menu →
IMAGE menu
→
Print the
Setup ←
Scan Line
↓
Imager Resolution
↓
Contrast Level
↓
System Test
↓
Automatic Media
Cut ↓
Show Transport
Parm ↓
Media Type
↓
Closed-loop
Control ↓
Fan Control
↓
Show Media
Remaining ↓
Luminance Level
↓
Reset All
Parameters ↓
Total Image
Footage ↓
Delay Plot ↓
Notes:
1. Arrows "
→ " and "← " mean pressing the MENU key; "↓ " means pressing the
ITEM key.
2. The TechSetter will go from the MENU mode (first row) to the ITEM mode after the
ITEM or the ENTER key is pressed.
3. The TechSetter will go back to the MENU mode from the ITEM mode
by pressing the MENU key.