Specifications

Chapter 4: Kiosk and Desktop Station Installation and Setup
4 – 3
Notes
Kiosk Specifications
Power and test kiosk
1 Open the cabinet and load blank cards into the encoder
hopper as shown on the label attached to the card hopper.
See Figure 4.2.
2 Place the card weight on top of the cards.
Specification Requirements
Space 1.83m H × 1.83m W
a
× 0.91m D
(6 ft H
× 6 ft W × 3 ft D)
a. Three feet of the width requirement is for service access.
Weight 300 lbs (approx)
Operating temp 0° – 40°C (32° – 104°F)
Storage temp 0° – 45°C (32° – 113°F)
Operating
humidity
10% – 90%
Storage
humidity
10% – 85%
Lighting Ambient
Power Standard 120VAC, 20 amp wall outlet
b
b. An uninterruptible power supply (UPS) is enclosed in the
kiosk station cabinet and will provide continuous power for
a minimum of 10 minutes. A redundant or additional back-
up power source may be necessary. See your Security or
Information Technology Administrator for specific require-
ments.
Physical secu-
rity and safety
Screw or bolt into the subfloor. Use the fol-
lowing fasteners:
Wood: Stainless steel lag screw: 18–8
1/4” dia, 3” length, McMaster-Carr®
#92351A554 or equivalent.
Concrete, brick or masonry: Stainless steel
bolt anchor: 18–8 1/4” dia, 3” length,
McMaster-Carr® #92405A198 or equivalent.